A aviation & planes forum. AviationBanter

If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Go Back   Home » AviationBanter forum » rec.aviation newsgroups
Site Map Home Register Authors List Search Today's Posts Mark Forums Read Web Partners

Post New Thread
Threads in Forum : Home Built Forum Tools Search this Forum Feed Icon
  Thread / Thread Starter Last Post Reverse Sort Order Replies Views
Mini Coupe by W P Dixon
Hi, Has anyone built Ron Dixon's Mini-Coupe? I like the look of the little plane and have been considering building one.
(Multi-page thread 1 2)
October 4th 04 03:26 PM
by Dan Thomas Go to last post
15 3,319
UL fly-in / Central FL by FlyingGatorJohn
http://www.mitchellwing.com/flying_gators_annual_fly.htm
October 4th 04 04:54 AM
by Gilan Go to last post
1 1,346
Bush's guard record by JDKAHN
I'd posted this in the "liar and fraud" thread but someone suggested nobody would see it as that thread had kinda petered out. It's a good summary of the reality of Bush's Guard record: "Juan Jimenez" wrote in message ... richard...
(Multi-page thread 1 2)
October 3rd 04 09:38 PM
by W P Dixon Go to last post
13 9,554
GNS430 Installation by Wayne Sweet
Anyone install a GNS430 to interface with a KI-209A CDI, Navaid Device autopilot and JPI EDM700 (let's see what else...)?? I'm removing my GX50 and Icom for this newer system. But if the GNS430 cannot be set for a enroute sensitivity of +-1 mn (vice 5 nm), as my GX50 can, then it's a show...
October 3rd 04 04:39 AM
by Wayne Sweet Go to last post
0 1,937
Fuel pump fittings by Evan Carew
-----BEGIN PGP SIGNED MESSAGE----- Hash: SHA1 Do I need to get those special (straight thread) fittings for my fuel pump or are the regular NPT AN fittings good enough. Thanks, Evan -----BEGIN PGP SIGNATURE----- Version: GnuPG v1.0.6 (GNU/Linux)
(Multi-page thread 1 2)
October 3rd 04 03:13 AM
by GeorgeB Go to last post
15 1,979
Testing Stick Ribs by Bob Hoover
Rib Testing The rib is supported upside down by a jig simulating the wing spars. The load, consisting of a single mass suitably divided by balance beams, is applied to the upper edge of the rib (as positioned in the jig), distributed by pallets of wood as needed to prevent...
October 3rd 04 02:30 AM
by smjmitchell Go to last post
3 2,593
Express Aircraft of Olympia WA quits by dancingstar
x-posted to rah,rao,rap Here's a news scoop for you all... Express Aircraft Company, formerly Wheeler Express, has gone out of business. Apparently TCM (Teledyne Continental Motors) was unable to honor shipment of their "Full Authority Digital Engine Control" (FADEC) IOF-550 engines which...
(Multi-page thread 1 2 3 ... Last Page)
October 3rd 04 12:57 AM
by Steelgtr62 Go to last post
59 6,418
V-8 powered Seabee by Corky Scott
Here's a link to view a successfull conversion from a Franklin powered Seabee to a Chevy LS-1 powered Seabee. The conversion has flown over 600 hours. Improvements in climb, cruise, fuel consumption and takeoff over original. Interestingly, the conversion makes more power than the Franklin...
(Multi-page thread 1 2 3 ... Last Page)
October 2nd 04 11:45 PM
by Ted Azito Go to last post
212 121,945
Good prices on Aeroshell oils at Sams club by Fastglasair
Do you guys know that you can purchase Aeroshell 15W50 and W100 or W80 at some Sams club locations. If yours does not stock, I was able to get mine in Ogden,UT to do so. I ordered 20 cases, this primed the pump to get them to stock and I spread the word to others to keep the demand up to keep it...
October 2nd 04 11:30 PM
by Ted Azito Go to last post
4 4,887
A&P by W P Dixon
Ok Guys and Gals, I have finally decided to check into what I have put off for about 20 years! Can any of you kind people refer me to a cheap A&P course. I have seen a couple in the 1000 buck range, I just can not justify that expense as I won't be using it for employment. I would prefer something...
October 2nd 04 05:16 AM
by W P Dixon Go to last post
7 799
WATCH YOUR $6 GROW INTO $30000IN JUST 2 WEEKS by [email protected]
http://charlestheboy.tripod.com/smallbusiness/
October 1st 04 09:24 PM
by [email protected] Go to last post
0 842
Homebuilts and radios! by
Hi, I am finishing the construction of a J-3. I intend to have the following in the aircraft and would like to know if you can give me any hints or suggestions on the type, location and mounting of the antenna farm. I would either like to hide the antennas or build them from scratch or kit. I am...
(Multi-page thread 1 2)
October 1st 04 09:18 PM
by Craig Go to last post
11 2,841
Scram Jets by Dude
Anyone know the slowest speed at which a scram jet would likely be able to start? It seems NASA is using a rocket booster to get to speed, which would make me think this idea is a bit less than practical for civilian use. Can't see the Concorde crowd signing up for a rocket powered plane, though...
October 1st 04 05:03 PM
by Dude Go to last post
5 808
SERFI by Dan Horton
The SouthEastern Regional Fly-In begins tomorrow at Middleton Field (GZH), Evergreen, Alabama. Great weather forecast, so ya'll come. Information at www.serfi.org includes the arrival proceedure.
October 1st 04 04:30 PM
by Orval Fairbairn Go to last post
3 1,031
Homebuilt Aircraft Frequently Asked Questions (FAQ) by Ron Wanttaja
Last revised on September 1, 2004. Added question on non-US homebuilding. This document attempts to answer common questions asked by newcomers to the rec.aviation.homebuilt newsgroup, or those curious individuals unfamiliar with the domain of homebuilt aircraft. It assumes that the reader already...
October 1st 04 02:31 PM
by Ron Wanttaja Go to last post
0 12,935
C & D NiMH Best Deal by Larry
Okay, I'll admit- I *thought* I'd found a good deal on NiMH AA batteries (posted on the previous thread), but you folks came through with some really great deals. I'm shopping for some NiMH size C and D batteries (already got a nice charger). Thus far I've seen a pack of 8 C and 8 D for $4.84...
October 1st 04 01:41 PM
by Vaughn Go to last post
6 1,269
An Erudite Discourse on the Relative Merits and Demerits of the Various Styles of Hangar Doors by jls
At the WNC Air Museum, the original hangar has sliding doors, big monstrous steel things sliding back and forth on rollers that are quite functional. In addition at the new museum hangar, wherein live six beauty airplanes (including three cherry Stearmans), are doors which rotate outward and...
October 1st 04 01:52 AM
by Capt.Doug Go to last post
1 1,993
How to use Lycoming remote filter by Evan Carew
-----BEGIN PGP SIGNED MESSAGE----- Hash: SHA1 - -----BEGIN PGP SIGNED MESSAGE----- Hash: SHA1 The attached picture (URL) shows the remote filter I got with my Lycoming O-235. Anyone know how to use this? Specifically, I would like to know what fittings one needs to get it going. I've determined...
September 30th 04 11:43 PM
by Evan Carew Go to last post
0 1,979
OT - humor (G-rated) by Rich S.
With all the OT stuff on rah lately, I hope you won't mind a little OT humor. It kinda goes along with all the political rhetoric we've been having. Rich S. ******************************************************** ORDERING A PIZZA IN 2008
September 30th 04 04:40 PM
by C J Campbell Go to last post
6 1,190
WHY NO NEW MSGS?? by Jerry J. Wass
DOES ANYONE ELSE have the same problem that I do-- no new msgs since 9-21-04 Half those that are there are expired?/-ERROR MSG !!
September 30th 04 12:50 PM
by Corky Scott Go to last post
1 411
Post New Thread


Display Options
Showing threads 4481 to 4500 of 6903
Sorted By Sort Order
From The
Forum Tools Search this Forum
Search this Forum :

Advanced Search

New posts New posts More than 15 replies or 150 views Hot thread with new posts
No new posts No new posts More than 15 replies or 150 views Hot thread with no new posts
Closed Thread Thread is closed  
 
Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

vB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump


All times are GMT +1. The time now is 01:38 PM.


Powered by vBulletin® Version 3.6.4
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.
Copyright ©2004-2025 AviationBanter.
The comments are property of their posters.