Mike Noel wrote:
The fellow who did my annual asked me to order a jack screw because he can
see a little wiggle between the screw and the cable drum. He wasn't sure
which part was worn, but suggested we start by replacing the screw and then
also replace the drum if the problem persists.

I would like to survey the experiece of the group before ordering the jack
screw. Is the screw more likely to wear than the cable drum, or do they
both tend to add equally to a loose fit?

I just went through this with my PA22/20. There are flat washers
(used as thrust washers) above and below the block though which
the jackscrew shaft runs. We were able to get the play out by
the replacing worn washers...

Google Groups it!

MikeM
Pacer '00Z
Skylane '1MM