"Ron Webb" wrote in message ...
Hello

Does anyone have any experience getting the bolt pattern off the
transmission side of an auto engine?

I'm building a PSRU, and I need to make the plate that bolts to the engine.
The rest of the pattern is generic, but that is engine specific.

I have tried several ways of measuring the holes in the block, but I'm sure
I can't get accuracy better than 1/10 inch or so. Surly engineering drawings
for these patterns are available somewhere.

Contact me off list and I will help ya. It is a pretty easy procedure.
Look at the pics of my set up and see if yours will be about the same.

http://www.zenithair.com/stolch801/builder-pics/bh2.jpg
http://www.zenithair.com/stolch801/builder-pics/bh1.jpg

Ben Haas N801BH