"pbc76049" wrote

Take a heat gun and warm the plastic locally to about 150ish.
This will remelt the glue holding the paper to the plastic and
leave you with squeaky clean plastic to work with. The glue used
is a low temp thermoset not a solvent based glue so liquids really
just get in the way and get sucked into the sheet to crreate problems
later.
Hope that sounded a bit better......

Much better, no doubt, and thanks for the info. I never had even considered
heat. I just hope this tidbit stays in my forgetful brain, until (not if,
but when) I need to remove some of that hateful old paper again.
--
Jim in NC