I think a "Dickfore" wrench will work for this nicely.

cavelamb wrote:
larry wrote:

"Dan" wrote in message
news:vvAag.29365$fG3.15672@dukeread09...

larry wrote:

My maintenance manual describes (what appears to be) a 90º gear drive
extension. I cannot identify it by part number, nor can I seem to
locate


a

source for purchase.

Details: http://www.turbinefun.com/SpecialTool.asp

Any help you could provide would be greatly appreciated.

Thanks for your help.
Larry



If you can get a torque wrench in where the 90º angle is you won't
need part 4. I have seen the tool to which you refer with a T handle
instead of a socket. Have you tried Sears? I don't recall where I saw
it.

Dan, U.S. Air Force, retired



I tried Sears, and will check with a different Snapon guy. The problem is
item 4 is in such a tight spot there's not enough room to swing a
handle of
any kind.

Larry



Sounds like a job for a "crowfoot"?

Richard