On 22 Sep 2003 08:40 PM, Roger Halstead posted the following:

As for my air system I run 175 psi and plastic is "to me" out of the
question. I have 1/2 galvanized installed. I gotta figure how to get
that monster out into a leanto on the back of the shop...even if it's
insulated with a little heat...It has to stay warm enough to keep the
condensate from freezing. It's not terribly noisy, but noisy enough
to startle you when it starts and you don't want to be doing some fine
work when it does. :-))

Get one of those orange 110v heating pads that you stick to the oil pan
of your car or airplane, and stick it to the bottom of your compressor
tank. I've got a similar sized compressor (used) sitting out in my shed,
and if/when I get around to hooking it up, that is what I am going to do.
No way am I going to put that sucker inside my workspace.

----------------------------------------------------
Del Rawlins-
Remove _kills_spammers_ to reply via email.
Unofficial Bearhawk FAQ website:
http://www.rawlinsbrothers.org/bhfaq/