On Sunday, August 12, 2012 3:36:31 PM UTC-4, Andy wrote:
On Aug 12, 10:15*am, wrote:

I had the same problem.

It is caused by the PCAS range setting.

This setting should be 9000 or smaller

Larger than 9000 will keep the orange LED on (indicating an error)



While that's almost true it is not quite accurate. 9250 is accepted

but 9300 is not.



Has anyone found out how to reset the brick to factory defaults? if

it's documented I haven't found it yet.



GY

The DATA PORT SPECIFICATION says the default PFLAC values are underlined. However, it also says:"Factory preset values can differ from default values."

There is no apparent single command to reset them all at once.

-Jim