On Jun 19, 5:12*pm, Perri Bachini Perri.Bachini.
wrote:
I recently bought a set of RevMaster VW I beam rods, they have 3/8 black
rod bolts with no name on them. I forgot what the torque spec was and
called RevMaster today but Joe was gone until Monday. Does anyone know
what the torque spec is. I searched the posts and found no info and
also searched RevMasters web site and only the ARP bolt torque was
listed for Honda/Accura engines. Thanks in advance
Perri

--
Perri Bachini

Try posting an inquiry on http://shoptalkforums.com
Those rods are probably generic ChinCom HiPo stuff, same thing all the
vendors are selling.
Is this the final assembly of this engine, or just the first "dry"
test assembly? If it's just a preliminary assembly to check
clearances, just use the manual rod bolt torque for stock rods, and
you should be good. In our slow speed engines, that MIGHT be good
enough for final, but IF those rod bolts are higher than stock
strength, you won't see any benefit from them unless you stretch them
to spec.