|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
October 24th 13, 11:02 AM
posted to rec.aviation.soaring
|
|||
|
|||
Instrument drawings
A month or so ago, I found a full size drawing for both 80mm and 57mm
instruments. Do you think I can find it now??. It was either wings and wheels, or cumulus soaring...can anyone give me a lead? Cheers Ian K 
|
|
#2
October 24th 13, 02:32 PM
posted to rec.aviation.soaring
|
|||
|
|||
|
Instrument drawings
http://www.craggyaero.com/Drawings/I...0Templates.pdf Even better I think is to use one of these to properly drill the screw holes http://www.cumulus-soaring.com/forbes.htm
|
|
#3
October 24th 13, 06:51 PM
posted to rec.aviation.soaring
|
|||
|
|||
|
Instrument drawings
Thats it, many thanks.
"son_of_flubber" wrote in message ... http://www.craggyaero.com/Drawings/I...0Templates.pdf Even better I think is to use one of these to properly drill the screw holes http://www.cumulus-soaring.com/forbes.htm
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 3-view drawings | Élodie | General Aviation | 2 | April 5th 08 11:40 PM |
| O-200 installation drawings | rpellicciotti | Home Built | 1 | November 28th 07 07:33 PM |
| UH-1 Drawings | JKimmel | Rotorcraft | 5 | November 21st 05 10:03 PM |
| 3 view drawings? | Brent | Products | 0 | September 17th 03 05:46 AM |
Linear Mode
