|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
June 19th 12, 02:07 PM
posted to rec.aviation.soaring
|
|||
|
|||
Winscore finish cylinder setup
I'm learning how to setup Winscore for a local club fun contest. So far it makes sense, but setting up the Finish Cylinder is a bit confusing. How do I set it up for a 500' agl min finish height? The finish settings have settings for the Top and Base of the Finish Gate Cylinder, both in ft MSL.
Kirk 66 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 2011 WINSCORE | Ron Gleason | Soaring | 9 | April 21st 11 04:11 AM |
| WinScore help | Spam | Soaring | 2 | September 6th 09 05:00 PM |
| How to add an IGC validation DLL to Winscore ? | Dave Nadler | Soaring | 1 | June 18th 09 08:22 PM |
| How does Winscore calculate finish altitude? | kirk.stant | Soaring | 46 | July 31st 07 08:38 PM |
| Visulalizing the Finish Cylinder | [email protected] | Soaring | 44 | March 25th 05 03:10 PM |
Threaded Mode