|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#2
September 22nd 03, 07:37 PM
|
|||
|
|||
Hankal wrote: What is the easiest way to brake the bead on a 600x6 tire. Put the wheel on a bench, place one end of a piece of 1x2 lumber on the tire next to the wheel, and beat on the other end with a medium size hammer. If you don't have access to a bench, a plank will do; just don't put the wheel on a hard surface. Another good method is to place the wheel under part of your car, put the base of a hydraulic jack on the tire next to the wheel, and attempt to jack up the car. Do *not* succeed at jacking up the car! George Patterson A man who carries a cat by the tail learns something that cannot be learned any other way. Samuel Clemens 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Tire Changer | Juan Jimenez | Aviation Marketplace | 0 | August 19th 04 03:58 AM |
| Tire inflation pressure | Paul Lee | Home Built | 80 | November 19th 03 08:56 AM |
| Nosewheel Shimmy and Scalloped Tire Redux, Plus | Larry Smith | Home Built | 2 | September 15th 03 05:03 PM |
| Scalloped Nosewheel Tire | Larry Smith | Home Built | 7 | September 12th 03 10:16 PM |
| Tire talc...baby powder? | No Spam | Owning | 12 | August 8th 03 06:03 PM |
Threaded Mode