|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#16
March 2nd 04, 10:49 PM
|
|||
|
|||
"G.R. Patterson III" wrote in message ... Mike Rapoport wrote: A little off topic, but how does *anyone* afford Snapon tools? Their 1/4 socket set is about $1100! I'm with you on that. They had a tent at Osh a few years ago, and I priced some stuff. I decided that my old Craftsman and Mac tools are good enough after all. If you were to use Snap-on for a while you would understand the cost and realize that Craftsman is pretty much in the crap category. George Patterson A diplomat is a person who can tell you to go to hell in such a way that you look forward to the trip. 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Camloc Installation Tools | jls | Home Built | 13 | May 7th 04 06:11 AM |
| EAA Chapte Tools | [email protected] | Home Built | 7 | March 8th 04 11:51 PM |
| What tools do you take? | Michael Horowitz | Home Built | 14 | March 4th 04 03:07 PM |
| FS: MORE of my aviation parts, tools, instruments on ebay | Bill Berle | Owning | 0 | January 14th 04 10:40 AM |
| Why do you buy Snap-on tools? | Anonymo421 | Home Built | 12 | November 9th 03 10:40 AM |
Threaded Mode