|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#11
February 15th 04, 10:57 PM
|
|||
|
|||
In Rich S. wrote:
"Del Rawlins" wrote in message ... My father in law once set a piece of titanium on fire that he was machining in a lathe. Sure it wasn't Magnesium? Titanium would be a real chore to turn in a reg'lar lathe, for sure. Yeah, I'm sure. He was working as a millwright in a pulp mill and they used titanium for a lot of fittings because it had better resistance than any other metal to the highly corrosive chemicals used in the mill. ---------------------------------------------------- Del Rawlins- Remove _kills_spammers_ to reply via email. Unofficial Bearhawk FAQ website: http://www.rawlinsbrothers.org/bhfaq/ 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Awesome, free anti-virus program | Ken Sandyeggo | Home Built | 23 | September 4th 03 07:29 PM |
Threaded Mode