|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#12
October 18th 04, 11:53 PM
|
|||
|
|||
Steelgtr62 wrote:
Some British engines used an oil passage through the carb venturi, a far more elegant solution. However using fuel injection or mounting the carburetor on top of the engine instead of underneath would largely obviate the problem. Fuel injection will help a lot, but mounting the carb on top makes almost no difference. Matt 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Heat treating 4130 | RAM | Home Built | 0 | July 18th 04 05:33 PM |
| Painting and air cooled motor? | CitizenX | Home Built | 5 | June 30th 04 01:47 PM |
| 28 volt pitot heat | B2431 | Home Built | 15 | April 17th 04 04:25 PM |
| Heat treating wing ribs | Holger Stephan | Home Built | 13 | February 4th 04 12:59 AM |
| Carb Temperature Gauge | fly_the_skies | Home Built | 6 | January 14th 04 04:32 PM |
Threaded Mode