|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#8
October 19th 04, 03:23 AM
|
|||
|
|||
Seriously, this is least painfull and most reliable approach.
You not only need to do the right thing, but also document what you did for the future... Keith "Matt Whiting" schrieb im Newsbeitrag ... Ron Webb wrote: Take the block to a machine shop with a CMM and they'll have your dimensions in no time. Matt 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Dennis Fetters Mini 500 | EmailMe | Home Built | 70 | June 21st 04 09:36 PM |
| Car engine FAA certified for airplane use | Cy Galley | Home Built | 10 | February 6th 04 03:03 PM |
| Objective Engine Discussion | Rick Maddy | Home Built | 26 | October 14th 03 04:46 AM |
| Ford V-6 engine work | Corky Scott | Home Built | 19 | August 21st 03 12:04 PM |
| Corky's engine choice | Corky Scott | Home Built | 39 | August 8th 03 04:29 AM |
Threaded Mode