Thanks for ideas on drilling a centered hole!

Or, you could put a drill bit the diameter of the rod in the drill
press. Drill into a well clamped piece of wood. Remove the bit. Insert
the rod into the hole you just made. Now the rod is concentric to the
chuck. Almost as accurate as a lathe, and no center-finding required.

Scott wrote:
Haven't made the tool yet, but I think I've narrowed it down to 2
possibilities. Either put the rod inside a piece of sqaure tubing and
scribe two lines across from opposite corners in which case the lines
will cross at the center of the square tube and thus the center of the
rod as well...or the method mentioned where the drill bit gets attached
to the drill press table and the rod gets chucked in the drill. The
only thing is that I think this method would make it as though you were
trying to with the drill motor reversed which might not make the
drilling action happen too fast ... have to try it and see...

Scott


Del Rawlins wrote:

On Sun, 17 Oct 2004 15:28:57 +0000, Scott
wrote:


Man, you guys are the greatest! Now this is how this newsgroup (and
all others) should be!! Helpful, curteous, non-political, etc. I
got a lot of great ideas on how to accomplish the task! Harry K.:
Great saying! I only need to build ONE, so making ONE alike ought to
be a piece of cake LOL!!



So how did you do it?

================================================== ==
Del Rawlins--
Unofficial Bearhawk FAQ website:
http://www.rawlinsbrothers.org/bhfaq/
Remove _kills_spammers_ to reply