|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#14
November 1st 04, 03:54 PM
|
|||
|
|||
Russell Kent wrote:
"Sid Knox" wrote: At this point, I think a test by temporarily fastening some scoops to the tops of the existing NACA ducts (as Corky posted above) is relatively easy to do and may disclose a lot. Be certain that the temporary scoops are well attached. Losing a scoop in flight is almost certain to cause it to pass through the prop disc, turning an interesting experiment into a way-too-exciting flight. Russell Kent Yeah, especially 200' up at the end of the runway! John 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Testing Stick Ribs | Bob Hoover | Home Built | 3 | October 3rd 04 03:30 AM |
| Pressure testing gone bad | Mark Hickey | Home Built | 17 | November 25th 03 03:29 AM |
| Looking for out of service main rotor blades for testing newro... | James Lloyd | Home Built | 0 | July 28th 03 11:27 PM |
| Looking for out of service main rotor blades for testing new rotor | Wright1902Glider | Home Built | 9 | July 28th 03 07:06 AM |
| Torsional Vibration Testing | B2431 | Home Built | 8 | July 25th 03 08:15 AM |
Threaded Mode