|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#11
November 18th 04, 05:06 AM
|
|||
|
|||
"Nathan Young" wrote If it is thin enough to bend with visegrips, could you cut it with a set of large bolt cutters?Or, is there enough room to rotate one of those little pipe cutters. No residue at all, from that. -- Jim in NC --- Outgoing mail is certified Virus Free. Checked by AVG anti-virus system (http://www.grisoft.com). Version: 6.0.797 / Virus Database: 541 - Release Date: 11/15/2004 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| A question on Airworthiness Inspection | Dave S | Home Built | 1 | August 10th 04 06:07 AM |
| Flight test report and intake leak question | nauga | Home Built | 11 | April 12th 04 05:12 PM |
| Question | Charles S | Home Built | 4 | April 5th 04 10:10 PM |
| Zenith Zodiac XL question | Mick | Home Built | 4 | January 14th 04 06:47 PM |
| Tecumseh Engine Mounting Question | jlauer | Home Built | 7 | November 16th 03 02:51 AM |
Threaded Mode