|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#6
February 17th 05, 03:32 PM
|
|||
|
|||
On Thu, 17 Feb 2005 08:16:21 -0500, Corky Scott
wrote: On Wed, 16 Feb 2005 13:19:39 -0600, "James M. Knox" wrote: Stealth Pilot wrote in m: to get a smooth outer layer I used a paste of resin and johnsons baby powder (talc) and squeegee'd this on to fill the weave but not much more than that. Run that one by me one more time? I haven't heard of this trick. Most people use something like microballoons mixed with the resin to create a sandable finish. Corky Scott thats it. I just checked the ingredients to the baby powder. talc, fragrance. sometimes I just do it for the fragrance :-) smells great while sanding it back. Stealth Pilot 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Homebuilt Aircraft Frequently Asked Questions (FAQ) | Ron Wanttaja | Home Built | 1 | January 2nd 04 10:02 PM |
| Homebuilt Aircraft Frequently Asked Questions (FAQ) | Ron Wanttaja | Home Built | 0 | October 2nd 03 04:07 AM |
| Ford V-6 engine work | Corky Scott | Home Built | 19 | August 21st 03 01:04 PM |
| Homebuilt Aircraft Frequently Asked Questions (FAQ) | Ron Wanttaja | Home Built | 4 | August 7th 03 06:12 AM |
| Homebuilt Aircraft Frequently-Asked Questions (FAQ) | Ron Wanttaja | Home Built | 0 | July 4th 03 05:50 PM |
Threaded Mode