|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
January 27th 05, 10:04 AM
|
|||
|
|||
Sanding composites
How do you know when you're beginning to sand into the glass cloth? Do
you simply sand until you have a smooth finish, then stop? Ot do you keep going? thanks, joe mcguckin 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| composites propeller | Philippe | Home Built | 2 | August 4th 04 11:45 AM |
| composites vs. aluminum | John C | Home Built | 23 | May 7th 04 05:31 AM |
| Marske Flying Wings workshop in composites | Matthew J Redsell | Home Built | 1 | February 10th 04 02:41 PM |
| Scaled Composites builds plane for solo nonstop globe circumnavigation attempt | David O | Home Built | 23 | October 30th 03 12:15 PM |
| Scaled Composites X-Prize vehicle flying again after mods | David O | Home Built | 0 | October 26th 03 06:47 AM |
Threaded Mode