|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#4
August 20th 05, 06:09 AM
|
|||
|
|||
"Cy Galley" wrote in message news  YmNe.45866$084.12269@attbi_s22...You could attend one of the workshops at AirVenture or one of the welding classes that the EAA has around the country. Short of that, are there good book(s) that you could teach yourself? I seem to recall practicing clusters with short sections, and putting a tire valve in it, and see if your welds will hold pressure. I think I saw that in BengalisIs (sp?) books. Is that a common practice to test the welds? The second part, IIRC, is tearing it apart, to check penetration and strength of the welds. 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| AC 43.13, welding and a hip-check | Michael Horowitz | Owning | 2 | June 27th 04 08:09 PM |
| "I Want To FLY!"-(Youth) My store to raise funds for flying lessons | Curtl33 | General Aviation | 7 | January 10th 04 12:35 AM |
| Small Aircraft Transportation System (SATS) first practical trial | Larry Dighera | Piloting | 0 | November 27th 03 04:11 PM |
| FA: WEATHER FLYING: A PRACTICAL BOOK ON FLYING | The Ink Company | Aviation Marketplace | 0 | November 5th 03 01:07 AM |
| TIG welding video? | Russell Duffy | Home Built | 3 | October 6th 03 06:55 AM |
Threaded Mode