![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#26
|
|||
|
|||
![]()
Juan Jimenez wrote:
wrote in message oups.com... Hmm, shifts the CG forward a tad reducing the counterweight needed up front, and thereby the total weight by a bit more too, right? Or don't the 5js need a forward counterweight. That's a very good observation. Yes, it does. On most BD-5J's you are required to have some type of ballast on the nose, usually lead bars. On Bishop's jets, the ones being used for surrogate cruise missile work for the military, we resolved this by replacing the huge NICAD batteries with gel cells and moving them forward behind the panel. We also moved just about everything else that could fit in there. The specialists who did the installation said they had never before managed to fit 2 pounds of **** in a 1 pound box. I can send you pictures of that installation if you like, it's amazing. I designed the panel layout but the real work was done by the installers. OK, you bought the project 98% complete then pay other people to do your work for you. Have you done anything at all on it? Dan, U.S. Air Force, retired |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Removing water repelent from fiberglass lay-up? | Roger | Home Built | 2 | December 2nd 04 11:15 PM |
You can now by water-slip inkjet decals by the sheet | Charlotte Gaisford | Restoration | 0 | November 8th 04 02:00 PM |
You can now by water-slip inkjet decals by the sheet | Charlotte Gaisford | Aviation Marketplace | 0 | November 8th 04 01:59 PM |
Removing old antennas | Jay Honeck | Owning | 30 | March 21st 04 04:34 PM |
Info needed to make decals for missiles | TJ | Simulators | 1 | January 16th 04 02:29 PM |