|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#7
December 5th 03, 03:29 AM
|
|||
|
|||
I was actually working on a temperature switch setup, one that would allow you to turn the switch on all the time, yet would not actually power it if the temperature was above say 5C or so. Something else to go wrong. Jose -- (for Email, make the obvious changes in my address) 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Pitot tube question | Doc Font | Home Built | 2 | January 24th 05 05:28 AM |
| Any metallurgist's on the group, I want to heat treat aluminum? | [email protected] | Home Built | 3 | December 11th 04 12:50 PM |
| Painting and air cooled motor? | CitizenX | Home Built | 5 | June 30th 04 01:47 PM |
| 28 volt pitot heat | B2431 | Home Built | 15 | April 17th 04 04:25 PM |
| Question about Question 4488 | [email protected] | Instrument Flight Rules | 3 | October 27th 03 02:26 AM |
Threaded Mode