|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#6
September 26th 05, 09:50 PM
|
|||
|
|||
Yankee Whiskey wrote:
Get an allen wrench, unlock it from the tray, yank it out, and take a look at the tag on the back. You're not going to hurt it. Will pulling the unit from the power supply cause it to revert back to its factory-set defaults? When my unit was pulled and repaired by Garmin (which reverted all settings back to their defaults), the avionics shop had to recalibrate my GNS480 with the HSI. -- Peter ----== Posted via Newsfeeds.Com - Unlimited-Uncensored-Secure Usenet News==---- http://www.newsfeeds.com The #1 Newsgroup Service in the World! 120,000+ Newsgroups ----= East and West-Coast Server Farms - Total Privacy via Encryption =---- 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Washington DC airspace closing for good? | tony roberts | Piloting | 153 | August 11th 05 01:56 AM |
| P-3C Ditches with Four Engines Out, All Survive! | Scet | Military Aviation | 6 | September 27th 04 02:09 AM |
| p3/95 | [email protected] | Military Aviation | 1 | September 27th 04 01:27 AM |
| B29 tail serial number Tarakan WW2 | Joanne Smedley | Military Aviation | 6 | August 13th 03 03:11 PM |
Threaded Mode