![]() |
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#15
|
|||
|
|||
|
On Fri, 06 Jan 2006 02:15:53 GMT, "Steven P. McNicoll"
wrote in . net:: "Larry Dighera" wrote in message .. . So the placement of the pivot point is immaterial? Well, where the pivot point is placed would determine which side of the pivot point had the greater surface area. I would think placement of the pivot point would determine the arm/moment of the moveable vane. Either end could have greater surface area than the other, but the end of the vane with greatest moment (surface area * arm) will trail in the breeze. |
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| I want to build the most EVIL plane EVER !!! | Eliot Coweye | Home Built | 237 | February 13th 06 04:55 AM |
| Most reliable homebuilt helicopter? | tom pettit | Home Built | 35 | September 29th 05 03:24 PM |
| Mini-500 Accident Analysis | Dennis Fetters | Rotorcraft | 16 | September 3rd 05 12:35 PM |
| Headwinds, always | Paul kgyy | Piloting | 36 | June 9th 05 02:05 AM |
| LX4000 wind calculation | AttentionLEcureuil | Soaring | 2 | June 23rd 04 05:33 AM |