![]() |
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#8
|
|||
|
|||
|
"Vaughn" wrote in message ... "Morgans" wrote in message ... This is for a HID with the starting ballast and power supply built into the bulb, so you don't have any expensive power supply to buy, right? If you can hook a 12 volt line to the bulb, and take off, then that sounds like a bargain. (if that is all you need) Since you must effectively buy a brand new ballast and power supply every time you need a new bulb, it somehow seems (to me at least) to fail the "bargain" test. For a bulb with no filament to break, with a expected "in use" burnout time of 2,000 hours, it is unlikely you will ever need to replace the bulk, and possibly the next dozen owners of the plane, as well. -- Jim in NC |
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Landing Light SOP | kristoffer-m20j | Piloting | 94 | November 4th 05 04:36 AM |
| "bush flying" in the suburbs? | [email protected] | Home Built | 85 | December 29th 04 12:04 AM |
| Slip to landing on PPG practical test | Roger Worden | Soaring | 56 | November 11th 04 10:38 PM |
| VW-1 C-121J landing with unlocked nose wheel | Mel Davidow LT USNR Ret | Military Aviation | 1 | January 19th 04 06:22 AM |
| Landing Gear Lights-Need Wiring Help | BG | Home Built | 2 | August 17th 03 12:21 AM |