|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#28
March 19th 06, 12:33 AM
posted to rec.aviation.homebuilt,sci.electronics.design
|
|||
|
|||
More LED's - Again
RST Engineering (jw) wrote:
The secret is HIGH GLOSS, LOW QUALITY photo paper. The high gloss means that the toner won't diffuse into the pores of the paper and the low quality means that the backing paper will soak off easily in hot sudsy water. I can hold long 10 mil lines and 10 mil gaps with relative ease. MUCH easier than press-n-peel. Jim Well, you da man, Jim. I'll give it a try. http://www.home.earthlink.net/~tp-1/rcatest.jpg Not as crisp as the original tiff file, but... 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| KX-155 LEDs | Steven Barnes | Owning | 21 | July 11th 13 09:04 AM |
| Nav Lights using Luxeon LEDs | Andrew Sarangan | Home Built | 28 | March 7th 06 09:18 PM |
| More LED's | Veeduber | Home Built | 19 | June 9th 04 10:07 PM |
| LEDs for Nav Lights - Jim Weir | Scott Gettings | Home Built | 3 | February 17th 04 01:53 AM |
| LEDs | Morgans | Home Built | 6 | August 19th 03 03:49 AM |
Threaded Mode