|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#6
June 10th 06, 12:25 AM
posted to rec.aviation.homebuilt
|
|||
|
|||
Welding question 2
"cavelamb" wrote But outdoors, the gas will blow away without shielding the weld. Flux core wire for outside work... I had not thought of that, but I have never welded outside of a shop, either. It has to do with big power supplies, and the availability outdoors, I suppose. -- Jim in NC 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Welding question - | Michael Horowitz | Restoration | 11 | September 7th 06 04:52 PM |
| Welding question: 43-13-1B, Fig.4-43 | Mike | Restoration | 0 | May 15th 06 03:36 PM |
| Aluminum welding | Ernest Christley | Home Built | 5 | April 24th 06 12:47 PM |
| Legal question - Pilot liability and possible involvement with a crime | John | Piloting | 5 | November 20th 03 10:40 PM |
| Special Flight Setup Question (COF) | Dudley Henriques | Simulators | 4 | October 11th 03 01:14 AM |
Threaded Mode