|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#10
June 15th 06, 12:03 AM
posted to rec.aviation.homebuilt
|
|||
|
|||
O/A welding question: tip size
"Morgans" wrote in
: "cavelamb" wrote Might I ask if there is a reason for holding 2 psi? That seems a tad low... I was wondering the same thing. I usually go with around 32 Oxy, and 7 Acet. I am surprised he could get a neutral flame with those settings, but he claims to know what a neutral flame is, and that he is getting it. I wonder if his gauges are off... 32psi? That sounds more like "cutting tip" O2 pressure, not welding. ???? 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Welding question - | Michael Horowitz | Restoration | 11 | September 7th 06 04:52 PM |
| Welding question: 43-13-1B, Fig.4-43 | Mike | Restoration | 0 | May 15th 06 03:36 PM |
| Aluminum welding | Ernest Christley | Home Built | 5 | April 24th 06 12:47 PM |
| Welding question | Mike | Restoration | 4 | February 20th 06 03:23 PM |
| Welding question | Michael Horowitz | Home Built | 1 | October 13th 05 10:53 PM |
Threaded Mode