Many transponders in close proximity

588 wrote:
Kilo Charlie wrote:

Hmm.....well maybe you missed this above from jettester Eric or he's
incorrect.....


Mode C (if you
have it) reports altitude, yet if the climb or descent rate is large
(let's say greater than 1500fpm) their equipment typically faults you
off the scope and does not report your altitude.

So, the aircraft climbing or descending at a high rate are the ones
they do NOT want to know about? This had better be wrong.

I suspect jettester's info may also be a little out of date. When did
he say he hung up his spurs?


Jack

Sorry to all: I've been gone away from my computer for the holiday!
(was soaring !)

Wow, I was trying to clear up a number of misconceptions that people
typically have concerning Transponders. Did not mean to stir up a
hornets nest. Billy Hill is telling the truth also... so don't
misconstrue my remarks.

It depends on the radar you have in your area. whether you have 'line
of sight' with the glider and transponder whether the controller can
"see" your transponder. This is a continuation of my previous comments.

#7. My comments are reflective of "current" equipment used by ATC and
probably more current transponders than any of you can afford. Not
much has changed in the last 18yrs. Yet, I confirmed my previous
statements with the ATC supervisor here in Wichita as being correct.

#8. If two or more of you are operating on the same squawk code, and
end up with converging tracks or converging altitudes (if Mode C
equipped), you WILL set off ATC's traffic warnings (unless they turn
them off for all other traffic in your/their vicinity).

#9. Transponders are a good thing to have if ATC can "see" you, and
their participating traffic has TCAS.. it will "point" you out to that
traffic. TCAS uses the ATC radar to relay your transponder code and
altitude (if Mode C equipped) to that traffic.

#10. I spoke truthfully about their (ATC) not seeing you if climbing
too rapidly (or descending). It may X'out your info on their scope as
well as your altitude.

#11. A transponder may have helped the Hawker to receive a TCAS warning
if ATC could "see" the glider transponder (line of sight), Mode C would
have reported its altitude, and MTI did not filter because the glider
was not circling. I confirmed that MTI is set 65K in this area.

Jettester (UP)