![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#9
|
|||
|
|||
![]()
"Daniel" wrote in message
om... Certificated by whom? Anybody with a chainsaw & a porta-mill can declare whatever grade they wish on any lumber they produce. Heck, take the basic quality designations for #2 construction lumber & see what percentage of the ordinary wall studs at Big Orange even meet the specs stamped on them. I think a plane builder is far better off performing his/her own pass/fail inspections than trusting Larry the Lumberjack to have done so correctly at the mill. Just like adhesives. Rich S. |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Homebuilt Aircraft Frequently Asked Questions (FAQ) | Ron Wanttaja | Home Built | 4 | August 7th 03 05:12 AM |
Homebuilt Aircraft Frequently-Asked Questions (FAQ) | Ron Wanttaja | Home Built | 0 | July 4th 03 04:50 PM |