|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#7
June 20th 07, 08:44 PM
posted to rec.aviation.homebuilt
|
|||
|
|||
cad-plated stainless steel?
"Dan" schrieb im Newsbeitrag ... El Maximo wrote: .... Stick a magnet to the part and see if it sticks. Magnets don't stick to stainless steel. small neodym magnet sticks to stainless as well as to steel pins, can't tell and difference. What is a recommended test for stainless (besids leaving it outside half a year and watch rusting)? 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Stainless steel exhaust | headwind | Home Built | 5 | February 14th 07 03:30 AM |
| nicopress sleeve for stainless steel cable | ls | Home Built | 3 | December 6th 05 04:09 PM |
| Working Stainless Steel | Bob Babcock | Home Built | 7 | February 14th 04 04:12 PM |
| OK, all you limeys: 4 beautiful chromium-plated valve covers for Continental O-200 | jls | Home Built | 5 | February 10th 04 05:36 PM |
| structural stainless steel tank screws needed for PA-32-300 | Dave | Owning | 11 | October 1st 03 10:14 PM |
Threaded Mode