|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
December 15th 07, 12:05 AM
posted to rec.aviation.homebuilt
|
|||
|
|||
sheet metal tab trimmer tool
Anybody seen a tool that trims little tabs on sheet metal flush with
the edge? I've heard of them but can't find where to purchase. Thanks. 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Deburring sheet metal and filing edges? | DL152279546231 | Home Built | 1 | April 25th 04 01:47 AM |
| Driving sheet-metal screws into 4130 | Grandpa B. | Home Built | 10 | February 3rd 04 08:23 PM |
| Sheet metal "Nibbler" | Nolaminar | Home Built | 3 | January 24th 04 07:05 AM |
| Sheet metal shear/press brake | VideoFlyer | Home Built | 7 | October 7th 03 08:08 PM |
Threaded Mode