![]() |
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#12
|
|||
|
|||
|
On 10/11/2012 7:05 PM, Uncle Fuzzy wrote:
On Thursday, October 11, 2012 3:10:36 PM UTC-7, JohnDeRosa wrote: On Wednesday, October 10, 2012 9:04:15 PM UTC-5, Uncle Fuzzy wrote: "His charging system is a piece of lamp cord cut to a length that delivers his desired charge current." Huh? The wire length limits the charge current? I may be dense but you are going to have to explain this to me a bit more. Wire has resistance, enough wire (his cord is approximately 30 feet long)has enough resistance to drop the charge current to his target 10 amps. That's an extrememly mild charge rate for an A123 cell pack that will happily discharge at 80 amps. Was that cheaper than buying a charger? Even if the wire was free, I think it'd be safer and cheaper in the long run to buy a charger that was smarter than a piece of wire. -- Eric Greenwell - Washington State, USA (change ".netto" to ".us" to email me) |
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| LiFePO4 battery | ASM | Soaring | 4 | December 6th 11 08:00 PM |
| AGM Batteries | Dave Anderer | Owning | 13 | March 29th 08 08:38 PM |
| 2-Batteries | [email protected] | Soaring | 69 | January 4th 07 05:09 AM |
| 160 new batteries | Mal | Soaring | 0 | October 27th 06 12:36 PM |
| Sealed Batteries | Gene Vignali | Owning | 5 | October 2nd 03 09:32 PM |