|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#3
November 19th 03, 04:50 AM
|
|||
|
|||
WRONG! WRONG!WRONG!
Read the manual again several times. Ironing is all done before you put on the Poly Brush. The only ironing done after the Poly Brush is to the pinked edges of the tapes. Put that iron out in the middle of the fabric and it will melt the Poly Brush leaving marks in it. Brush marks are leveled out by the spray coats of Poly Brush and Poly Spray which is last. Correct on the pink. The pink tint is only there so you can see where you have been and is not recommended inside the cockpit unless it is painted. 
|
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode