|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#11
February 26th 15, 11:24 PM
posted to rec.aviation.soaring
|
|||
|
|||
CNC Waterjet cutting instrument holes
After designing the panel on AutoCAD, I sent the .dwg file to Severn Valley Sailplanes in the UK. They made the fibreglass panel and CNC cut the holes.. They did an outstanding job, produced a delamination-free panel and shipped it to my door. If I was to try to find a negative it would be the wait before starting as they had a number of jobs on. But for experienced pros, definitely worth the wait.
CJ B3 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Trying to fill some holes in the instrument panel | [email protected] | Soaring | 2 | February 12th 14 03:55 AM |
| Cutting 57mm holes in the instrument panel.....how to? | John Bojack[_2_] | Soaring | 20 | November 12th 10 10:15 PM |
| When Poorboys drill holes ...was: Drilling holes in steel tubing | wright1902glider | Home Built | 4 | November 4th 05 02:19 AM |
| Cutting shirttails??? | Larry Dighera | Soaring | 11 | September 3rd 03 04:34 PM |
Threaded Mode