![]() |
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
|
|||
|
|||
|
Mylar seals continue to come loose from my PIK.
Some have been there for some years and leave a yellowish residue of dried adhesive which can be easily scraped off as a powder;other sections have the carrying film left behind and a sticky adhesive layer on the wing; this needs solvent for removal. At least two types of double sided tape have been used; one from W and W came with a roll of mylar; the other source was a stationary supply store product. Recently I found a dispenser of double sided film trade mark "Studio". This is el cheapo and not to be trusted. Any good brand experiences with double sided adhesive film? It is always the mylar face which lets go. I have till Sat to make a choice when replacing three lost sections. cheers JMF |
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| high-stregth transfer tape | Paul Gaines | Soaring | 4 | April 18th 15 08:14 AM |
| Transfer of IGC log for contest scoring | Tom N. | Soaring | 22 | February 21st 07 10:15 PM |
| Technology transfer? | Rich S. | Home Built | 4 | June 30th 05 07:58 PM |
| Transfer registration from Canada to US | joe | Rotorcraft | 2 | June 24th 04 01:58 PM |
| Fuel Transfer Placards | Ben Smith | Owning | 22 | October 16th 03 03:32 PM |