|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
October 15th 04, 08:14 PM
|
|||
|
|||
Bolt torque
I'm about to do some final torquing of bolts and I want to make sure
I have the right torque numbers. A DOT Inspection and Repair manual chart states that an AN-3 bolt with an AN-365 nut ( fine thread ) should be torqued to 20-25 inch pounds. Is this correct? Thanks Neal 
|
|
#2
October 16th 04, 06:57 AM
|
|||
|
|||
|
With that nut (tension type) this is the correct torque.
You would use a lower torque (12-15 in lb) for a shear type nut (i.e. AN364) See Chapter 5 of AC43.13-1A (or 1B - the later rev) for further details. "Neal Fulco" wrote in message om... I'm about to do some final torquing of bolts and I want to make sure I have the right torque numbers. A DOT Inspection and Repair manual chart states that an AN-3 bolt with an AN-365 nut ( fine thread ) should be torqued to 20-25 inch pounds. Is this correct? Thanks Neal
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| V-8 powered Seabee | Corky Scott | Home Built | 212 | October 2nd 04 11:45 PM |
| piston connecting rod bolt replacement | Dick | Home Built | 5 | October 7th 03 02:34 PM |
| Trike wing bolt size | Aaron Smith | Home Built | 0 | September 30th 03 03:02 AM |
| Prop bolt torque setting | Whunicut | Home Built | 2 | September 4th 03 12:12 PM |
| Brake caliper flange | Stealth Pilot | Home Built | 5 | July 7th 03 04:19 PM |
Linear Mode
