|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
May 24th 05, 11:23 PM
|
|||
|
|||
A-65 mechanic question
My A-65 had the lower half redone.
At operating temp. and at idle, the oil pressure is certainly below 15PSI and may be below 10. I asked the company that did the work and they replied "we don't worry about low pressure at idle". Continental says a minimum of 10PSI. I'll get my A&P to put a real pressure gauge on to see what the pressure is. In your experience, does idle typically produce less than 15PSI or am I looking at a problem? 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 182RG question | Paul Anton | Owning | 11 | May 16th 05 09:45 PM |
| Good morning or good evening depending upon your location. I want to ask you the most important question of your life. Your joy or sorrow for all eternity depends upon your answer. The question is: Are you saved? It is not a question of how good | Excelsior | Home Built | 0 | April 22nd 05 01:11 AM |
| molding plexiglas websites? | [email protected] | Owning | 44 | February 17th 05 09:33 PM |
Threaded Mode