If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Tanis Pre-heater with Engine Analyzer
Does anyone out there have experience with having installed a tanis
heater when a engine analyzer is already in place. I have a JPI Classic Scanner (EGT/CHT) that had bayonnet-type probee for CHT. Tanis has a kit designed for this sitation, but after we installed the kit, none of the CHT readings worked at all. The installer called Tanis and JPI and did get very useful advice on what may be going wrong. Has anyone out there faced this problem (and successfully overcome it)? -Sami Piper Arrow III N2057M |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Proposals for air breathing hypersonic craft. I | Robert Clark | Military Aviation | 2 | May 26th 04 06:42 PM |
Car engine FAA certified for airplane use | Cy Galley | Home Built | 10 | February 6th 04 03:03 PM |
What if the germans... | Charles Gray | Military Aviation | 119 | January 26th 04 11:20 PM |
Objective Engine Discussion | Rick Maddy | Home Built | 26 | October 14th 03 04:46 AM |
Corky's engine choice | Corky Scott | Home Built | 39 | August 8th 03 04:29 AM |