One here in NZ had a void of 14-15 inchs long,the engineers here think
the problem has been from making the glue mixture to thin and it has just
flowed out of the rear side as there is a ridged edge on the front side to
make all the mix go towards the rear.
One comment made was they thought that the factory had attempted to
push some mix into that void by hand by reaching through the access point
but had only been partially successful
gary
"Duane Eisenbeiss" wrote in message
news:rQDhb.533114$Oz4.430152@rwcrnsc54...

"Duane Eisenbeiss" wrote in message
news:3fRab.527488$uu5.88216@sccrnsc04...
Enough time has past such that several DuoDiscus wings must have been
inspected. However, there have been no reports as to what was found
during
the inspection or what, if anything had to be done. All owner should
communicate with each other so that we all can have a better handle on
what
is happening to the fleet.
Duane

The report for the inspection of ship S/N 217 has been received. The left
wing had 1 small void. The right wing had 4 small voids.

Has anyone had an inspection that revealed large voids? say larger than
12
inches or 30 cm.

Duane