I would want to "stop waypoint sequencing", so the unit doesn't
sequence to the next waypoint in the middle of your approach. Make the
"Ixxx" the active waypoint, then put the unit in OBS (or HOLD) mode.
Putting the unit in OBS mode stops waypoint sequencing. Dial in the
localizer track as read off the plate. This will give you a track line
to the localizer and beyond it. It is usually easiest to have the Ixxx
waypoint in the route.

"Richard Kaplan" wrote in message ws.com...
"Greg Esres" wrote in message
...


Anyone have a tip as to the best way to enter the LOC DME source on
the KLN94?


Set up a flight plan or go direct and treat it just like any other waypoint,
but be sure to start it with an I, i.e. IAFJ.