Eric Greenwell wrote:

I attended Boerman's lecture. The problem isn't thin, laminar flow
airfoils in general, but some specific designs over the last two decades
or so that have a "flat spot" in the lift coefficient (Cl) curve as the
angle of attack (AOA) approaches stall. Normally, the Cl increases with
increasing AOA, but in the flat spot region, it remains constant (or
nearly so) even as the AOA increases. Past this region, Cl begins to
increase again with AOA at the usual rate.

I should add that designers were aware of the flat spot years ago, but
did not appreciate the problems it could cause in gusty conditions.

--
Eric Greenwell - Washington State, USA
* Change "netto" to "net" to email me directly

* Updated! "Transponders in Sailplanes" http://tinyurl.com/y739x4
* New Jan '08 - sections on Mode S, TPAS, ADS-B, Flarm, more

* "A Guide to Self-launching Sailplane Operation" at www.motorglider.org