"bildan" wrote in message ...

The interest for me is a sailplane installation where AOA is a
performance issue in addition to a safety issue.

My glider can be flown at 1000 pounds up to 1433 pounds gross weight
and spends a lot of time in 2G turns thermalling. The AOA for minimum
sink is always the same but the airspeed at which that happens changes
a lot. The same thing with best L/D.

A very 'slippery' glider takes a while for the airspeed to settle down
after a pitch change. Flying to an exact AOA would be easier than
chasing airspeed.

An AOA indicator that shows minimum sink and maximum L/D as well as
stall would be quite useful.

Bill,

I tatally agree! It would also be nice to have the AOA measure units instead of degrees and be calibrated so to give the same readings for max L/D and Min Sink at all flap settings.

When I was flying A-6 Intruders 21 units of AOA was the Max Range value (best L/D) at all flap settings. I don't believe you can develop an effective unit for aircraft with flaps without integrating the flap setting into the system. This requires knowing the performance curve for each setting in order to calculate a single Max L/D (Max Range) indicator reading and a single Min Sink (Max endurance) indicator reading.

This isn't as simple of a problem as some seem to think it is.

Wayne
HP-14 with flap settings from -5 to +90.
http://www.soaridaho.com/Schreder