|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
October 22nd 04, 07:28 PM
|
|||
|
|||
adjustable prop bearing
For all you prop gurus out there...
A ran across this drawing and something struck me as odd... why is the prop blade only being held in with one bearing? Wouldn't it want to rotate about this bearing slightly and put a lot of force on the pitch change mechanism? Or in other words, why isn't the blade held rigidly? http://www.mt-propeller.com/pdf/datsheet/mtv-23.pdf Joe 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Right prop, wrong prop? Wood prop, metal prop? | Gus Rasch | Aerobatics | 1 | February 14th 08 10:18 PM |
| Ivo Prop on O-320 | Dave S | Home Built | 14 | October 15th 04 03:04 AM |
| IVO props... comments.. | Dave S | Home Built | 16 | December 6th 03 11:43 PM |
| Hydraulic CS prop converting to Adjustable prop? | Scott VanderVeen | Home Built | 0 | December 5th 03 05:54 PM |
| Metal Prop vs. Wood Prop | Larry Smith | Home Built | 21 | September 26th 03 07:45 PM |
Threaded Mode