|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
January 10th 06, 01:31 AM
posted to rec.aviation.homebuilt
|
|||
|
|||
Torque wrenches...
Anyone know any good sources for these.
It seems like I will be needing a nice repeatable one in the 5-100 in/lb range for 10-32 screws and nuts. I am not sure what the torque is that I will be using, the screws are AN509-R10 (MS24694 #10) and the nuts are MS21040-3. I have seen from 20 in/lbs to 60 in/lbs for these. TIA -- Dan DeVillers http://www.ameritech.net/users/ddevillers/start.html .. 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Continental A-75 hub torque | SteveR | Home Built | 8 | July 21st 05 10:49 PM |
| Proper Torque for Fuel Fittings | Steve Waltner | Home Built | 10 | February 20th 05 01:46 AM |
| Torque values for oil screen | John Clonts | Owning | 2 | January 25th 05 01:01 AM |
| Drum dia and torque | Bob Johnson | Soaring | 15 | November 22nd 04 08:37 PM |
| Prop bolt torque setting | Whunicut | Home Built | 2 | September 4th 03 01:12 PM |
Threaded Mode