|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
April 27th 07, 06:41 AM
posted to rec.aviation.homebuilt
|
|||
|
|||
brake fittings
Can I connect aluminum AN fittings to steel hose ends? I am
planning on using Earl's Speed-Flex hose with Speed-Seal hose ends on my Avid Mark IV with Grove gear and Matco brakes. Will there be corrosion from the mating of dissimilar metals? Thanks. 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Pnuematic air line fittings? | Michael Baldwin, Bruce | Products | 0 | December 31st 06 10:41 AM |
| Brass Compression Fittings,Fittings for Pex-Al-Pex Sale on good price | valvetom | Piloting | 0 | November 27th 06 05:58 PM |
| AN Fittings | Bruce A. Frank | Home Built | 4 | May 6th 05 04:11 PM |
| Fuel pump fittings | Evan Carew | Home Built | 15 | October 3rd 04 03:13 AM |
| Need advice on Aeroquip fittings | Corky Scott | Home Built | 2 | December 12th 03 12:46 AM |
Threaded Mode