|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
February 24th 04, 12:51 PM
|
|||
|
|||
Metal working...
Any suggestions for a good text and/or discussions about metal shrinking, dinging, stretching, etc. I would like to
learn to form aluminum into scoops and other shapes. I know it is a practice, practice, practice (almost) art form. Thanks all! -- Dan D. .. 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Right prop, wrong prop? Wood prop, metal prop? | Gus Rasch | Aerobatics | 1 | February 14th 08 11:18 PM |
| Working Stainless Steel | Bob Babcock | Home Built | 7 | February 14th 04 05:12 PM |
| New JAR-VLA certified all metal basic trainer and quick build KIT plane. | marcin | Home Built | 0 | October 13th 03 01:32 PM |
| Sheet metal shear/press brake | VideoFlyer | Home Built | 7 | October 7th 03 08:08 PM |
| Metal Prop vs. Wood Prop | Larry Smith | Home Built | 21 | September 26th 03 08:45 PM |
Threaded Mode