![]() |
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
|
|||
|
|||
|
I will be looking for a 1-man wing rigger for a DG-1000 at the SSA-Convention. Ours (it seems to be a standard DG rigger) appears to be to weak for the heavy DG wings. The linear roller-bearings have bent, and the balls are falling out. Also, when the wings are flat (in flight config), the rigger-upright is either leaning to the right or left because of wing-holder flexing..
Heinz Gehlhaar |
|
#2
|
|||
|
|||
|
Come by my booth (MM Fabrication LLC) and talk to me.
|
|
#3
|
|||
|
|||
|
On Saturday, January 27, 2018 at 11:26:56 PM UTC-8, Heinz Gehlhaar wrote:
I will be looking for a 1-man wing rigger for a DG-1000 at the SSA-Convention. Ours (it seems to be a standard DG rigger) appears to be to weak for the heavy DG wings. The linear roller-bearings have bent, and the balls are falling out. Also, when the wings are flat (in flight config), the rigger-upright is either leaning to the right or left because of wing-holder flexing. Heinz Gehlhaar Hello Heinz: I have a Cobra electric rigger for Duo Discus and similar listed on glider source (below) and can deliver it to the SSA convention in Reno. Jim http://www.glidersource.com/cgi-bin/post.cgi?id=1218 |
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Looking to buy a wing rigger. | Marcin S | Soaring | 4 | July 19th 17 03:13 PM |
| Looking for a wing rigger for an asw 20 | Marcin S | Soaring | 1 | July 10th 17 03:21 AM |
| Ka6 wing rigger | James Koper | Soaring | 2 | June 22nd 17 04:23 PM |
| Wing Rigger | Dan Marotta | Soaring | 2 | September 3rd 16 03:54 PM |
| Looking for a used wing rigger / one man rigger .... | [email protected] | Soaring | 0 | November 6th 13 07:02 PM |