|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
August 18th 04, 10:26 PM
|
|||
|
|||
Test Prop Question
I'm about ready to test run my Corvair engine and finally
realized the old VW prop laying in the hanger wouldn't work bolt pattern-wise even though both rotate in the same direction (opposite of Continental/Lycomings). My question is "what can I use temporarily"? I have an old Continental wood prop with damaged tips (separate story) that I could cut down or even reverse mount.. 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Right prop, wrong prop? Wood prop, metal prop? | Gus Rasch | Aerobatics | 1 | February 14th 08 11:18 PM |
| Prop Pitch Question | Eugene Wendland | Home Built | 2 | April 25th 04 04:22 AM |
| Flight test report and intake leak question | nauga | Home Built | 11 | April 12th 04 05:12 PM |
| IVO props... comments.. | Dave S | Home Built | 16 | December 7th 03 12:43 AM |
| Metal Prop vs. Wood Prop | Larry Smith | Home Built | 21 | September 26th 03 08:45 PM |
Linear Mode
